Flat ribbon rose.
When I started making ribbon flowers a few days ago I wanted them to decorate a black jacket. But the flowers I picked were to large and dimensional to decorate the jacket. So I started looking for flowers that would work and found the flat ribbon rose. It is quite lovely and flat and can be made as large as desired. So today I made one and took pictures so I could share on this blog. I used a nearly 1 inch wide polyester satin ribbon.
Ribbon with crinoline.
All you need to make a flat ribbon rose is ribbon, crinoline, and a sharp strong needle like a milliners.
To start cut a piece of thread about 12 inches and make a knot. Using the whole length of ribbon tie a knot at the end. Don't tighten it to much, it needs to be bulky because it becomes the flower center.
Knotted ribbon.
Sew the ribbon to the center of the piece of crinoline.
Fold the ribbon at an angle across the knot. Then stitch the ribbon to the crinoline with small stitches. Fold under the ribbon edge toward the middle of the flower. The stitch down both edges of the ribbon with a couple of small stitches. Always stitch the ribbon where the stitches won't show. Or where the next folds will cover the stitches. Keep folding and stitching until the rose looks the right size to you.
When the rose is the right size cut the ribbon and the fold the ribbon edge under and stitch the end. The last step is to fold under the beginning ribbon edge and secure it to the crinolin. Now that it is done carefully cut the rose from the crinolin paying attension to both the front and the back so the thread and the ribbon don't get cut. I hope that someone will try and make these roses. They would make a wonderful decoration for a wedding gift!
